SP6AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1763728075	86 Count	665 Count	36 Count
1763726274	84 Count	656 Count	35 Count
1763724473	83 Count	644 Count	35 Count
1763722673	82 Count	639 Count	35 Count
1763720872	80 Count	631 Count	34 Count
1763719071	78 Count	622 Count	33 Count
1763717271	76 Count	616 Count	32 Count
1763715470	75 Count	612 Count	32 Count
1763713669	73 Count	604 Count	31 Count
1763710077	69 Count	589 Count	29 Count
1763708277	67 Count	560 Count	28 Count
1763701074	62 Count	505 Count	27 Count
1763699272	61 Count	505 Count	27 Count
1763697472	60 Count	505 Count	27 Count
1763695671	59 Count	502 Count	27 Count
1763693870	57 Count	494 Count	26 Count
1763692070	56 Count	483 Count	26 Count
1763690269	55 Count	472 Count	26 Count
1763688475	54 Count	470 Count	26 Count
1763684874	52 Count	454 Count	26 Count
1763679472	47 Count	393 Count	24 Count
1763677671	46 Count	365 Count	24 Count
1763675870	44 Count	324 Count	23 Count
1763674070	42 Count	305 Count	22 Count
1763672269	41 Count	267 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)