UN9GIE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN9GIE-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1787573212	508 Count	957 Count
1787572608	507 Count	955 Count
1787572004	506 Count	955 Count
1787571401	505 Count	955 Count
1787570861	504 Count	955 Count
1787570194	503 Count	953 Count
1787569591	502 Count	953 Count
1787567780	499 Count	949 Count
1787567177	498 Count	948 Count
1787565970	496 Count	946 Count
1787565366	495 Count	944 Count
1787564762	494 Count	942 Count
1787564159	493 Count	942 Count
1787562952	491 Count	938 Count
1787562348	490 Count	938 Count
1787561807	489 Count	936 Count
1787561141	488 Count	935 Count
1787559892	487 Count	935 Count
1787559287	486 Count	931 Count
1787558684	485 Count	930 Count
1787558081	484 Count	928 Count
1787557503	483 Count	924 Count
1787556394	481 Count	921 Count
1787555791	480 Count	919 Count
1787555187	479 Count	916 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)