F4MLV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4MLV-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772570589	144 Count	218 Count	139 Count
1772550628	143 Count	218 Count	139 Count
1772547065	40 Count	65 Count	40 Count
1772545261	605 Count	1057 Count	585 Count
1772543457	574 Count	996 Count	555 Count
1772541654	547 Count	936 Count	529 Count
1772539850	517 Count	889 Count	500 Count
1772538046	487 Count	839 Count	471 Count
1772536242	454 Count	782 Count	439 Count
1772534438	418 Count	716 Count	404 Count
1772532635	354 Count	616 Count	341 Count
1772530831	293 Count	516 Count	281 Count
1772529027	251 Count	446 Count	241 Count
1772488028	250 Count	446 Count	241 Count
1772486224	218 Count	387 Count	210 Count
1772484420	196 Count	344 Count	189 Count
1772482616	174 Count	308 Count	168 Count
1772480813	150 Count	264 Count	145 Count
1772479009	129 Count	228 Count	125 Count
1772477205	100 Count	180 Count	97 Count
1772475401	76 Count	140 Count	74 Count
1772466931	74 Count	139 Count	73 Count
1772465166	44 Count	84 Count	44 Count
1772463362	673 Count	1023 Count	564 Count
1772461559	646 Count	976 Count	538 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)