SP6KBU-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6KBU-13. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765279108	282 Count	116 Count	116 Count
1765277306	275 Count	111 Count	111 Count
1765277048	270 Count	111 Count	111 Count
1765276501	264 Count	110 Count	110 Count
1765276148	259 Count	110 Count	110 Count
1765275518	253 Count	109 Count	109 Count
1765275066	245 Count	106 Count	106 Count
1765274877	243 Count	106 Count	106 Count
1765274361	237 Count	105 Count	105 Count
1765273307	234 Count	104 Count	104 Count
1765273180	228 Count	103 Count	103 Count
1765271991	220 Count	101 Count	101 Count
1765270890	215 Count	99 Count	99 Count
1765270422	207 Count	97 Count	97 Count
1765269301	200 Count	95 Count	95 Count
1765269189	199 Count	95 Count	95 Count
1765267458	194 Count	92 Count	92 Count
1765265651	189 Count	89 Count	89 Count
1765263849	183 Count	85 Count	85 Count
1765262047	178 Count	82 Count	82 Count
1765260245	172 Count	78 Count	78 Count
1765258443	167 Count	75 Count	75 Count
1765256641	161 Count	71 Count	71 Count
1765254839	156 Count	68 Count	68 Count
1765253037	151 Count	65 Count	65 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)