SM0MMC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0MMC-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765503557	179 Count	21 Count	11 Count
1765499950	178 Count	21 Count	11 Count
1765496347	177 Count	21 Count	11 Count
1765492754	176 Count	21 Count	11 Count
1765489141	175 Count	21 Count	11 Count
1765485538	174 Count	21 Count	11 Count
1765481953	173 Count	21 Count	11 Count
1765478350	171 Count	21 Count	11 Count
1765474747	170 Count	21 Count	11 Count
1765471144	168 Count	21 Count	11 Count
1765467541	167 Count	21 Count	11 Count
1765463937	166 Count	21 Count	11 Count
1765460352	165 Count	21 Count	11 Count
1765456749	164 Count	21 Count	11 Count
1765453146	163 Count	21 Count	11 Count
1765449543	162 Count	21 Count	11 Count
1765445940	161 Count	21 Count	11 Count
1765442337	160 Count	21 Count	11 Count
1765438751	159 Count	21 Count	11 Count
1765435148	158 Count	21 Count	11 Count
1765431545	157 Count	21 Count	11 Count
1765427942	156 Count	21 Count	11 Count
1765424339	155 Count	21 Count	11 Count
1765420736	154 Count	21 Count	11 Count
1765417151	153 Count	21 Count	11 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)