SP8SOB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SOB-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1778073318	738 Count	659 Count	550 Count
1778072418	734 Count	656 Count	547 Count
1778071517	730 Count	653 Count	544 Count
1778070616	726 Count	650 Count	541 Count
1778069716	722 Count	647 Count	538 Count
1778068815	719 Count	645 Count	536 Count
1778067914	716 Count	643 Count	534 Count
1778067013	713 Count	641 Count	532 Count
1778066113	710 Count	639 Count	530 Count
1778065212	707 Count	637 Count	528 Count
1778064311	703 Count	634 Count	525 Count
1778063410	699 Count	631 Count	522 Count
1778062510	695 Count	628 Count	519 Count
1778061609	692 Count	626 Count	517 Count
1778060708	688 Count	623 Count	514 Count
1778059808	684 Count	620 Count	511 Count
1778058933	681 Count	618 Count	509 Count
1778058006	678 Count	616 Count	507 Count
1778057105	674 Count	613 Count	504 Count
1778056205	670 Count	610 Count	501 Count
1778055304	666 Count	607 Count	498 Count
1778054403	662 Count	604 Count	495 Count
1778051346	658 Count	602 Count	493 Count
1778050424	655 Count	600 Count	491 Count
1778049508	652 Count	598 Count	489 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)