This is the latest recevied telemetry packets stored in our database for station/object SP7TBU-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
TX*
RX*
Digi*
V_Bat*
V_Ext*
1787582156
218 Count
686 Count
108 Count
0 VDC
0 VDC
1787577352
208 Count
686 Count
108 Count
0 VDC
0 VDC
1787576151
206 Count
686 Count
108 Count
0 VDC
0 VDC
1787570147
192 Count
686 Count
108 Count
0 VDC
0 VDC
1787562956
179 Count
686 Count
108 Count
0 VDC
0 VDC
1787560554
177 Count
686 Count
108 Count
0 VDC
0 VDC
1787559354
176 Count
686 Count
108 Count
0 VDC
0 VDC
1787555751
168 Count
684 Count
108 Count
0 VDC
0 VDC
1787554551
167 Count
684 Count
108 Count
0 VDC
0 VDC
1787553350
156 Count
668 Count
101 Count
0 VDC
0 VDC
1787552267
149 Count
642 Count
96 Count
0 VDC
0 VDC
1787550951
141 Count
594 Count
92 Count
0 VDC
0 VDC
1787549748
128 Count
556 Count
82 Count
0 VDC
0 VDC
1787548547
121 Count
536 Count
78 Count
0 VDC
0 VDC
1787547391
119 Count
535 Count
78 Count
0 VDC
0 VDC
1787544943
103 Count
513 Count
68 Count
0 VDC
0 VDC
*Used Equation Coefficients:
TX: 0, 1, 0
RX: 0, 1, 0
Digi: 0, 1, 0
V_Bat: 0, 0.01, 0
V_Ext: 0, 0.02, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)