SP2SGL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773188540	243 Count	322 Count	218 Count
1773186739	234 Count	311 Count	210 Count
1773184939	229 Count	305 Count	206 Count
1773183138	222 Count	297 Count	200 Count
1773181337	215 Count	289 Count	194 Count
1773179537	205 Count	278 Count	185 Count
1773177736	199 Count	271 Count	180 Count
1773175935	191 Count	263 Count	173 Count
1773174143	184 Count	255 Count	167 Count
1773172342	174 Count	243 Count	158 Count
1773170541	169 Count	236 Count	154 Count
1773168740	161 Count	227 Count	147 Count
1773166940	155 Count	220 Count	142 Count
1773165139	146 Count	210 Count	134 Count
1773163338	140 Count	203 Count	129 Count
1773159737	127 Count	185 Count	118 Count
1773157936	113 Count	167 Count	105 Count
1773156135	103 Count	151 Count	96 Count
1773152542	68 Count	107 Count	63 Count
1773150741	58 Count	94 Count	54 Count
1773148940	50 Count	82 Count	47 Count
1773147140	37 Count	63 Count	35 Count
1773145339	27 Count	48 Count	26 Count
1773143538	9 Count	23 Count	9 Count
1773141737	746 Count	1015 Count	681 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)