SP8C-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8C-13. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1776707536	76 Count	76 Count	76 Count
1776705735	76 Count	76 Count	76 Count
1776703935	76 Count	76 Count	76 Count
1776702142	76 Count	76 Count	76 Count
1776700342	76 Count	76 Count	76 Count
1776698542	76 Count	76 Count	76 Count
1776696742	76 Count	76 Count	76 Count
1776694942	51 Count	51 Count	51 Count
1776693142	37 Count	37 Count	37 Count
1776691341	37 Count	37 Count	37 Count
1776689541	37 Count	37 Count	37 Count
1776687741	37 Count	37 Count	37 Count
1776685941	37 Count	37 Count	37 Count
1776684141	37 Count	37 Count	37 Count
1776682341	37 Count	37 Count	37 Count
1776680541	37 Count	37 Count	37 Count
1776678741	37 Count	37 Count	37 Count
1776676940	37 Count	37 Count	37 Count
1776675140	37 Count	37 Count	37 Count
1776673340	37 Count	37 Count	37 Count
1776671540	37 Count	37 Count	37 Count
1776669740	37 Count	37 Count	37 Count
1776667940	37 Count	37 Count	37 Count
1776666140	37 Count	37 Count	37 Count
1776664340	37 Count	37 Count	37 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)