SP3HUO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3HUO-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784694515	230 Count	32 Count	25 Count
1784692713	225 Count	32 Count	25 Count
1784690912	220 Count	32 Count	25 Count
1784689111	214 Count	30 Count	24 Count
1784687310	208 Count	27 Count	23 Count
1784685509	202 Count	25 Count	22 Count
1784683708	196 Count	23 Count	21 Count
1784681907	191 Count	21 Count	20 Count
1784680105	185 Count	19 Count	19 Count
1784678304	180 Count	19 Count	19 Count
1784676503	175 Count	19 Count	19 Count
1784674702	170 Count	19 Count	19 Count
1784671099	163 Count	19 Count	19 Count
1784669298	158 Count	19 Count	19 Count
1784667497	153 Count	19 Count	19 Count
1784665710	149 Count	19 Count	19 Count
1784663923	144 Count	19 Count	19 Count
1784662122	139 Count	19 Count	19 Count
1784660321	134 Count	19 Count	19 Count
1784658520	129 Count	19 Count	19 Count
1784656719	124 Count	19 Count	19 Count
1784654918	119 Count	19 Count	19 Count
1784653116	112 Count	19 Count	19 Count
1784651315	106 Count	18 Count	18 Count
1784649514	97 Count	14 Count	14 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)