EA2ESA-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA2ESA-13. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Battery*	WiFiQuality*	RFQuality*
1784689416	31 %	33 status	80 status
1784688815	31 %	33 status	81 status
1784688214	31 %	34 status	81 status
1784687613	31 %	33 status	81 status
1784687013	31 %	33 status	81 status
1784686412	31 %	33 status	81 status
1784685811	31 %	33 status	81 status
1784685210	31 %	33 status	80 status
1784684609	31 %	33 status	81 status
1784684008	31 %	33 status	81 status
1784683408	31 %	33 status	81 status
1784682807	31 %	33 status	81 status
1784682206	31 %	34 status	81 status
1784681605	31 %	33 status	81 status
1784681004	31 %	33 status	81 status
1784680403	31 %	33 status	81 status
1784679802	31 %	33 status	81 status
1784679201	31 %	33 status	81 status
1784678600	31 %	32 status	81 status
1784678000	31 %	33 status	81 status
1784677399	31 %	33 status	81 status
1784676798	31 %	33 status	82 status
1784676197	31 %	34 status	81 status
1784675596	31 %	34 status	81 status
1784674995	31 %	33 status	81 status

*Used Equation Coefficients:

Battery: 0, 1, 0

WiFiQuality: 0, 1, 0

RFQuality: 0, 1, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)