SN9GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SN9GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784704261	23 Count	813 Count
1784702460	22 Count	786 Count
1784700660	21 Count	752 Count
1784698859	20 Count	723 Count
1784697058	19 Count	693 Count
1784695257	18 Count	658 Count
1784693465	17 Count	623 Count
1784691664	16 Count	589 Count
1784689863	15 Count	553 Count
1784688062	14 Count	523 Count
1784686262	13 Count	488 Count
1784684461	12 Count	453 Count
1784682660	11 Count	416 Count
1784680859	10 Count	382 Count
1784679058	9 Count	345 Count
1784677258	8 Count	308 Count
1784675457	7 Count	265 Count
1784673656	6 Count	231 Count
1784671865	5 Count	191 Count
1784670064	4 Count	150 Count
1784666462	2 Count	83 Count
1784664661	1 Count	49 Count
1784662861	0 Count	25 Count
1784661060	20 Count	1022 Count
1784659259	19 Count	995 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)