F1ZZF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1ZZF-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Rx'ed*	Digi'ed*	Decode*
1784703826	61 Packet	7 Packet	77 %
1784700106	57 Packet	5 Packet	74 %
1784696387	54 Packet	4 Packet	77 %
1784692667	55 Packet	5 Packet	74 %
1784688947	43 Packet	3 Packet	67 %
1784685227	42 Packet	3 Packet	65 %
1784681507	41 Packet	3 Packet	66 %
1784677787	43 Packet	3 Packet	70 %
1784674067	42 Packet	4 Packet	68 %
1784670347	45 Packet	4 Packet	70 %
1784666627	47 Packet	3 Packet	69 %
1784662908	45 Packet	3 Packet	65 %
1784659188	50 Packet	5 Packet	72 %
1784655468	46 Packet	7 Packet	68 %
1784651748	50 Packet	5 Packet	69 %
1784648028	55 Packet	4 Packet	75 %
1784644308	58 Packet	8 Packet	76 %
1784640588	61 Packet	9 Packet	76 %
1784636869	57 Packet	6 Packet	74 %
1784633149	67 Packet	8 Packet	73 %
1784629429	71 Packet	10 Packet	78 %
1784625709	68 Packet	10 Packet	76 %
1784614549	67 Packet	7 Packet	83 %
1784610830	59 Packet	6 Packet	83 %
1784607110	63 Packet	11 Packet	80 %

*Used Equation Coefficients:

Rx'ed: 0, 1, 0

Digi'ed: 0, 1, 0

Decode: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)