This is the latest recevied telemetry packets stored in our database for station/object DK3ACH-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
Time
Press*
Temp.in*
Hum*
QNH*
Temp.out*
1788469235
1002.4 hPa
23.8 C deg
67.5 %
1020.6 hPa
0 C deg
1788467407
1002.4 hPa
23.8 C deg
67.2 %
1020.6 hPa
0 C deg
1788465574
1002.4 hPa
23.9 C deg
66.4 %
1020.6 hPa
0 C deg
1788463745
1002.5 hPa
23.9 C deg
65.7 %
1020.7 hPa
0 C deg
1788461917
1002.4 hPa
24 C deg
64.5 %
1020.6 hPa
0 C deg
1788460099
1002.2 hPa
24 C deg
63.8 %
1020.4 hPa
0 C deg
1788458255
1002.4 hPa
24.1 C deg
63.1 %
1020.6 hPa
0 C deg
1788456424
1002.2 hPa
24.1 C deg
62.8 %
1020.4 hPa
0 C deg
1788454593
1002.2 hPa
24 C deg
62.5 %
1020.4 hPa
0 C deg
1788451010
1001.9 hPa
24.2 C deg
61.6 %
1020.1 hPa
0 C deg
*Used Equation Coefficients:
Press: 0, 1, 0
Temp.in: 0, 1, 0
Hum: 0, 1, 0
QNH: 0, 1, 0
Temp.out: 0, 1, 0
The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0). The sent equation coefficients is used in the equation: a * value2 + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)