SR8NZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8NZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780889726	985 Count	1 Count	1 Count
1780889669	984 Count	1 Count	1 Count
1780889604	983 Count	1 Count	1 Count
1780889543	982 Count	1 Count	1 Count
1780889483	981 Count	1 Count	1 Count
1780889422	980 Count	1 Count	1 Count
1780889361	979 Count	1 Count	1 Count
1780889300	978 Count	1 Count	1 Count
1780889240	977 Count	1 Count	1 Count
1780889179	976 Count	1 Count	1 Count
1780889118	975 Count	1 Count	1 Count
1780889057	974 Count	1 Count	1 Count
1780888997	973 Count	1 Count	1 Count
1780888935	972 Count	1 Count	1 Count
1780888874	971 Count	1 Count	1 Count
1780888814	970 Count	1 Count	1 Count
1780888753	969 Count	1 Count	1 Count
1780888692	968 Count	1 Count	1 Count
1780888631	967 Count	1 Count	1 Count
1780888571	966 Count	1 Count	1 Count
1780888514	965 Count	1 Count	1 Count
1780888449	964 Count	1 Count	1 Count
1780888389	963 Count	1 Count	1 Count
1780888328	962 Count	1 Count	1 Count
1780888267	961 Count	1 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)