F4GCF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GCF-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1788571435	761 Count	429 Count
1788570835	747 Count	420 Count
1788570235	722 Count	405 Count
1788569634	696 Count	393 Count
1788569034	668 Count	378 Count
1788568434	635 Count	359 Count
1788567834	612 Count	347 Count
1788567262	595 Count	341 Count
1788566634	572 Count	328 Count
1788566034	557 Count	320 Count
1788565434	537 Count	310 Count
1788564834	515 Count	297 Count
1788564234	502 Count	288 Count
1788563633	491 Count	282 Count
1788563032	475 Count	275 Count
1788562432	459 Count	266 Count
1788561832	446 Count	257 Count
1788561231	428 Count	246 Count
1788560631	414 Count	239 Count
1788560031	398 Count	230 Count
1788559431	385 Count	222 Count
1788558831	373 Count	217 Count
1788558231	362 Count	212 Count
1788557631	344 Count	203 Count
1788557031	333 Count	196 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)