4K3HF-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K3HF-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1775067662	302 Count	2 Count
1775066758	301 Count	2 Count
1775065855	300 Count	2 Count
1775064952	299 Count	2 Count
1775064048	298 Count	2 Count
1775063145	297 Count	2 Count
1775062242	296 Count	2 Count
1775061338	295 Count	2 Count
1775060435	294 Count	2 Count
1775059531	293 Count	2 Count
1775058628	292 Count	2 Count
1775057725	291 Count	2 Count
1775056821	290 Count	2 Count
1775055918	289 Count	2 Count
1775055015	288 Count	2 Count
1775054192	287 Count	2 Count
1775053289	286 Count	2 Count
1775052385	285 Count	2 Count
1775051482	284 Count	2 Count
1775050579	283 Count	2 Count
1775049675	282 Count	2 Count
1775048772	281 Count	2 Count
1775047868	280 Count	2 Count
1775046965	279 Count	2 Count
1775046062	278 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)