DG0OKW-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG0OKW-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1772639612	0 C deg	26.2 C deg
1772637793	0 C deg	26.2 C deg
1772635993	0 C deg	26.2 C deg
1772634160	0 C deg	26.2 C deg
1772632345	0 C deg	26.2 C deg
1772630530	0 C deg	26.2 C deg
1772628711	0 C deg	26.2 C deg
1772626896	0 C deg	26.2 C deg
1772625081	0 C deg	26.2 C deg
1772623266	0 C deg	26.2 C deg
1772621448	0 C deg	26.2 C deg
1772619633	0 C deg	26.2 C deg
1772617818	0 C deg	26.2 C deg
1772616003	0 C deg	26.2 C deg
1772614184	0 C deg	26.2 C deg
1772612369	0 C deg	26.2 C deg
1772610573	0 C deg	26.2 C deg
1772608739	0 C deg	26.2 C deg
1772606921	0 C deg	26.2 C deg
1772605106	0 C deg	26.2 C deg
1772603298	0 C deg	26.2 C deg
1772601476	0 C deg	26.2 C deg
1772599661	0 C deg	26.2 C deg
1772597846	0 C deg	26.2 C deg
1772596034	0 C deg	26.2 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)