SP2AJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2AJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789960572	232 Count	314 Count	199 Count
1789959671	225 Count	305 Count	193 Count
1789958770	219 Count	296 Count	188 Count
1789957869	211 Count	286 Count	181 Count
1789956968	205 Count	277 Count	176 Count
1789956068	199 Count	269 Count	171 Count
1789955189	191 Count	259 Count	164 Count
1789954266	186 Count	251 Count	160 Count
1789953365	179 Count	242 Count	154 Count
1789952464	173 Count	234 Count	149 Count
1789951564	166 Count	225 Count	143 Count
1789950663	159 Count	215 Count	137 Count
1789949762	154 Count	208 Count	133 Count
1789948861	148 Count	200 Count	128 Count
1789947960	142 Count	191 Count	123 Count
1789947060	136 Count	183 Count	118 Count
1789946159	131 Count	175 Count	114 Count
1789945258	127 Count	169 Count	111 Count
1789944357	120 Count	160 Count	105 Count
1789943456	114 Count	152 Count	100 Count
1789942556	108 Count	143 Count	95 Count
1789941655	103 Count	136 Count	91 Count
1789940754	93 Count	123 Count	82 Count
1789939871	88 Count	116 Count	78 Count
1789938970	79 Count	103 Count	70 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)