SP6RSP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RSP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1781330256	279 Count	1012 Count	170 Count
1781329655	271 Count	980 Count	165 Count
1781329054	261 Count	949 Count	159 Count
1781328454	253 Count	906 Count	155 Count
1781327853	240 Count	849 Count	145 Count
1781327252	230 Count	804 Count	139 Count
1781326652	221 Count	779 Count	134 Count
1781326051	213 Count	748 Count	129 Count
1781325450	203 Count	715 Count	123 Count
1781324874	193 Count	689 Count	117 Count
1781324274	183 Count	649 Count	110 Count
1781323673	176 Count	622 Count	107 Count
1781323072	165 Count	599 Count	100 Count
1781322472	154 Count	561 Count	92 Count
1781321871	144 Count	529 Count	86 Count
1781321270	136 Count	509 Count	82 Count
1781320670	126 Count	466 Count	75 Count
1781320069	117 Count	429 Count	70 Count
1781319468	110 Count	409 Count	67 Count
1781318867	102 Count	376 Count	62 Count
1781318266	92 Count	344 Count	56 Count
1781317666	83 Count	318 Count	51 Count
1781317065	74 Count	287 Count	45 Count
1781316464	65 Count	253 Count	40 Count
1781315864	57 Count	226 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)