SQ9MJ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9MJ-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784712198	54 Count	863 Count	33 Count
1784711320	53 Count	846 Count	33 Count
1784710419	52 Count	823 Count	33 Count
1784709518	51 Count	772 Count	33 Count
1784708617	46 Count	709 Count	29 Count
1784707716	37 Count	654 Count	21 Count
1784706815	34 Count	610 Count	19 Count
1784705914	33 Count	558 Count	19 Count
1784705013	32 Count	514 Count	19 Count
1784704112	31 Count	478 Count	19 Count
1784703211	30 Count	432 Count	19 Count
1784702310	29 Count	387 Count	19 Count
1784701409	14 Count	328 Count	5 Count
1784700508	13 Count	300 Count	5 Count
1784699607	7 Count	242 Count	0 Count
1784698706	6 Count	217 Count	0 Count
1784697805	5 Count	179 Count	0 Count
1784696904	4 Count	143 Count	0 Count
1784696003	3 Count	114 Count	0 Count
1784695103	2 Count	84 Count	0 Count
1784694202	1 Count	58 Count	0 Count
1784693301	0 Count	28 Count	0 Count
1784692400	36 Count	1003 Count	0 Count
1784691499	35 Count	978 Count	0 Count
1784690598	34 Count	950 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)