SQ2ME-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2ME-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1788573880	928 Count	77 Count
1788570279	928 Count	77 Count
1788568479	928 Count	77 Count
1788566679	928 Count	77 Count
1788564879	928 Count	77 Count
1788563079	928 Count	77 Count
1788561279	928 Count	77 Count
1788559479	928 Count	77 Count
1788557679	928 Count	77 Count
1788555879	928 Count	77 Count
1788554078	928 Count	77 Count
1788552278	928 Count	77 Count
1788550478	928 Count	77 Count
1788548678	927 Count	76 Count
1788546878	927 Count	76 Count
1788545078	927 Count	76 Count
1788543278	927 Count	76 Count
1788541478	927 Count	76 Count
1788539678	927 Count	76 Count
1788537878	927 Count	76 Count
1788536078	927 Count	76 Count
1788534278	927 Count	76 Count
1788532478	927 Count	76 Count
1788530678	927 Count	76 Count
1788528878	927 Count	76 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)