LB3AG-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LB3AG-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788648850	528 Count	934 Count	394 Count
1788648247	524 Count	928 Count	391 Count
1788647644	520 Count	919 Count	388 Count
1788647041	517 Count	915 Count	386 Count
1788646438	513 Count	908 Count	383 Count
1788645835	509 Count	899 Count	380 Count
1788645232	506 Count	894 Count	378 Count
1788644628	502 Count	888 Count	375 Count
1788644025	499 Count	883 Count	373 Count
1788643422	496 Count	878 Count	371 Count
1788642819	492 Count	871 Count	368 Count
1788642216	488 Count	863 Count	365 Count
1788641613	485 Count	858 Count	363 Count
1788641010	481 Count	854 Count	360 Count
1788640407	476 Count	839 Count	356 Count
1788639804	473 Count	832 Count	354 Count
1788639201	466 Count	822 Count	348 Count
1788638708	461 Count	814 Count	344 Count
1788638105	458 Count	807 Count	342 Count
1788637502	452 Count	796 Count	337 Count
1788636899	449 Count	789 Count	335 Count
1788636296	445 Count	780 Count	332 Count
1788635693	439 Count	771 Count	327 Count
1788635090	435 Count	765 Count	324 Count
1788634487	432 Count	759 Count	322 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)