OE3CJB-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE3CJB-4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1781382681	0 C deg	17.9 C deg
1781380866	0 C deg	18.7 C deg
1781379048	0 C deg	19.8 C deg
1781377232	0 C deg	21.1 C deg
1781375417	0 C deg	22.2 C deg
1781373606	0 C deg	23.4 C deg
1781371791	0 C deg	24.1 C deg
1781369976	0 C deg	24.9 C deg
1781368161	0 C deg	25.4 C deg
1781366346	0 C deg	25.8 C deg
1781364531	0 C deg	26.2 C deg
1781362716	0 C deg	26.6 C deg
1781360901	0 C deg	27.4 C deg
1781359086	0 C deg	27.1 C deg
1781357271	0 C deg	26.5 C deg
1781355456	0 C deg	26.5 C deg
1781353643	0 C deg	26 C deg
1781351828	0 C deg	26.6 C deg
1781350011	0 C deg	27.1 C deg
1781348196	0 C deg	27.2 C deg
1781346381	0 C deg	27.1 C deg
1781344581	0 C deg	26.6 C deg
1781342754	0 C deg	26.6 C deg
1781340937	0 C deg	26.8 C deg
1781339122	0 C deg	30.8 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)