SP9KKK-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784696110	8 Count	387 Count
1784694909	6 Count	244 Count
1784693708	3 Count	119 Count
1784692507	35 Count	1060 Count
1784691306	31 Count	933 Count
1784690117	28 Count	820 Count
1784688916	24 Count	739 Count
1784687715	21 Count	622 Count
1784686514	18 Count	501 Count
1784685313	14 Count	410 Count
1784684112	9 Count	306 Count
1784682911	6 Count	198 Count
1784681710	2 Count	108 Count
1784680509	32 Count	1124 Count
1784679308	29 Count	996 Count
1784678108	25 Count	897 Count
1784676907	22 Count	791 Count
1784675715	19 Count	660 Count
1784674530	15 Count	581 Count
1784673314	12 Count	473 Count
1784672113	9 Count	333 Count
1784670912	5 Count	247 Count
1784669711	2 Count	135 Count
1784668510	41 Count	1043 Count
1784667309	37 Count	942 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)