SH3JHL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SH3JHL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780597225	203 Count	412 Count
1780595425	202 Count	412 Count
1780593624	201 Count	412 Count
1780591823	200 Count	412 Count
1780590023	199 Count	412 Count
1780588222	198 Count	412 Count
1780586428	197 Count	412 Count
1780584627	196 Count	412 Count
1780582827	195 Count	412 Count
1780581026	194 Count	412 Count
1780579225	193 Count	412 Count
1780577425	192 Count	412 Count
1780575624	191 Count	412 Count
1780573824	190 Count	412 Count
1780572023	189 Count	412 Count
1780570222	188 Count	412 Count
1780568422	187 Count	412 Count
1780566621	186 Count	412 Count
1780564828	185 Count	412 Count
1780563027	184 Count	412 Count
1780561227	183 Count	412 Count
1780559426	182 Count	412 Count
1780557625	181 Count	412 Count
1780555836	180 Count	412 Count
1780554024	179 Count	412 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)