SQ3NVZ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3NVZ-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1781653193	10 Count	75 Count	7 Count
1781651392	218 Count	1007 Count	139 Count
1781649591	210 Count	964 Count	135 Count
1781647789	202 Count	908 Count	131 Count
1781646018	195 Count	887 Count	128 Count
1781644217	185 Count	857 Count	122 Count
1781642416	178 Count	837 Count	119 Count
1781640615	170 Count	810 Count	115 Count
1781638814	159 Count	730 Count	112 Count
1781637012	151 Count	672 Count	108 Count
1781635211	124 Count	597 Count	85 Count
1781633410	115 Count	553 Count	80 Count
1781631608	107 Count	473 Count	76 Count
1781629807	90 Count	385 Count	63 Count
1781628006	68 Count	305 Count	45 Count
1781626204	51 Count	261 Count	32 Count
1781624403	40 Count	170 Count	27 Count
1781622602	17 Count	79 Count	14 Count
1781620800	167 Count	1032 Count	86 Count
1781618999	157 Count	975 Count	80 Count
1781617198	144 Count	925 Count	71 Count
1781615397	128 Count	855 Count	59 Count
1781613596	117 Count	783 Count	54 Count
1781611794	83 Count	691 Count	33 Count
1781609993	75 Count	606 Count	30 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)