SP3PSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3PSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784702184	95 Count	625 Count	45 Count
1784700383	94 Count	625 Count	45 Count
1784698583	92 Count	608 Count	44 Count
1784696782	90 Count	587 Count	43 Count
1784694981	89 Count	570 Count	43 Count
1784693180	87 Count	566 Count	42 Count
1784691380	85 Count	563 Count	41 Count
1784689587	79 Count	558 Count	40 Count
1784687786	75 Count	549 Count	37 Count
1784685986	73 Count	544 Count	36 Count
1784684185	72 Count	543 Count	36 Count
1784682384	70 Count	535 Count	35 Count
1784680583	67 Count	525 Count	33 Count
1784678782	65 Count	521 Count	32 Count
1784676982	63 Count	515 Count	31 Count
1784675181	62 Count	512 Count	31 Count
1784673380	61 Count	511 Count	31 Count
1784671579	57 Count	502 Count	28 Count
1784669779	54 Count	498 Count	26 Count
1784667986	47 Count	493 Count	24 Count
1784666185	44 Count	489 Count	22 Count
1784664385	42 Count	486 Count	21 Count
1784662584	39 Count	479 Count	19 Count
1784660783	38 Count	479 Count	19 Count
1784658982	37 Count	478 Count	19 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)