OE1TKS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE1TKS-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	400Ah*	WrOUT*
1761519305	12 Volt	0 +Watt
1761518705	12 Volt	0 +Watt
1761518407	12 Volt	0 +Watt
1761518105	12 Volt	0 +Watt
1761517505	11.93 Volt	0 +Watt
1761517205	11.93 Volt	0 +Watt
1761516905	11.93 Volt	0 +Watt
1761516005	11.78 Volt	0 +Watt
1761515705	11.78 Volt	0 +Watt
1761515407	11.7 Volt	0 +Watt
1761515105	11.63 Volt	0 +Watt
1761514805	11.63 Volt	0 +Watt
1761514214	11.4 Volt	0 +Watt
1761513905	11.33 Volt	0 +Watt
1761513606	11.1 Volt	164 +Watt
1761513305	11.18 Volt	332 +Watt
1761513005	11.4 Volt	352 +Watt
1761512114	11.85 Volt	352 +Watt
1761511805	11.93 Volt	348 +Watt
1761511505	12 Volt	368 +Watt
1761511205	12.15 Volt	364 +Watt
1761510905	12.23 Volt	412 +Watt
1761510605	12.38 Volt	396 +Watt
1761510305	12.38 Volt	408 +Watt
1761510005	12.45 Volt	376 +Watt

*Used Equation Coefficients:

Solar: 0, 0.23, 0

Solar: 0, 8.9, -1139.2

Solar: 0, 0.19, -24.32

400Ah: 0, 0.075, 0

WrOUT: 0, 4, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)