DK8VW-99 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DK8VW-99. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1789972076	0 C deg	17.9 C deg
1789972055	0 C deg	17.9 C deg
1789968395	0 C deg	18 C deg
1789966565	0 C deg	18 C deg
1789964784	0 C deg	18.1 C deg
1789964735	0 C deg	18.1 C deg
1789962905	0 C deg	18.1 C deg
1789961074	0 C deg	18.2 C deg
1789959314	0 C deg	18.2 C deg
1789959244	0 C deg	18.2 C deg
1789957445	0 C deg	18.3 C deg
1789957414	0 C deg	18.3 C deg
1789955584	0 C deg	18.4 C deg
1789953754	0 C deg	18.4 C deg
1789951936	0 C deg	18.5 C deg
1789951924	0 C deg	18.5 C deg
1789950106	0 C deg	18.6 C deg
1789950094	0 C deg	18.6 C deg
1789948264	0 C deg	18.6 C deg
1789946434	0 C deg	18.7 C deg
1789944637	0 C deg	18.8 C deg
1789944604	0 C deg	18.8 C deg
1789942893	0 C deg	18.9 C deg
1789942774	0 C deg	18.9 C deg
1789940954	0 C deg	18.9 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)