SP6RTS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RTS-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1776675524	3 Count	653 Count	218 Count
1776674624	3 Count	653 Count	218 Count
1776673724	3 Count	653 Count	218 Count
1776672824	3 Count	653 Count	218 Count
1776671924	3 Count	653 Count	218 Count
1776671024	3 Count	653 Count	218 Count
1776670123	3 Count	653 Count	218 Count
1776669223	3 Count	653 Count	218 Count
1776668327	3 Count	653 Count	218 Count
1776667427	3 Count	653 Count	218 Count
1776666526	3 Count	653 Count	218 Count
1776665626	3 Count	653 Count	218 Count
1776664726	3 Count	653 Count	218 Count
1776663826	3 Count	650 Count	215 Count
1776662926	3 Count	650 Count	215 Count
1776662026	3 Count	650 Count	215 Count
1776661126	3 Count	650 Count	215 Count
1776660225	3 Count	650 Count	215 Count
1776659325	3 Count	650 Count	215 Count
1776658425	3 Count	650 Count	215 Count
1776657525	3 Count	650 Count	215 Count
1776656624	3 Count	650 Count	215 Count
1776655724	3 Count	650 Count	215 Count
1776654824	3 Count	650 Count	215 Count
1776653924	3 Count	650 Count	215 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)