SP8PB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8PB-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784717731	98 Count	848 Count
1784716830	97 Count	838 Count
1784715930	96 Count	833 Count
1784715029	95 Count	824 Count
1784714128	94 Count	817 Count
1784713227	93 Count	809 Count
1784712327	92 Count	802 Count
1784711426	91 Count	791 Count
1784710542	90 Count	782 Count
1784709624	89 Count	776 Count
1784708724	88 Count	768 Count
1784707823	87 Count	763 Count
1784706922	86 Count	754 Count
1784706022	85 Count	744 Count
1784705121	84 Count	737 Count
1784704228	83 Count	729 Count
1784703319	82 Count	720 Count
1784702419	81 Count	712 Count
1784701518	80 Count	703 Count
1784700617	79 Count	693 Count
1784699716	78 Count	685 Count
1784698816	77 Count	673 Count
1784697915	76 Count	664 Count
1784697014	75 Count	655 Count
1784696114	74 Count	640 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)