HB9EZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9EZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772568587	148 Count	437 Count	51 Count
1772567684	147 Count	433 Count	51 Count
1772565951	144 Count	428 Count	50 Count
1772565071	143 Count	426 Count	50 Count
1772564145	142 Count	411 Count	50 Count
1772563242	139 Count	402 Count	48 Count
1772562339	138 Count	398 Count	48 Count
1772561436	136 Count	386 Count	47 Count
1772560533	135 Count	385 Count	47 Count
1772559630	134 Count	382 Count	47 Count
1772558727	132 Count	379 Count	46 Count
1772557824	131 Count	375 Count	46 Count
1772556921	129 Count	370 Count	45 Count
1772555115	126 Count	352 Count	44 Count
1772554212	124 Count	337 Count	43 Count
1772553308	123 Count	330 Count	43 Count
1772552406	122 Count	325 Count	43 Count
1772550599	120 Count	313 Count	43 Count
1772549696	119 Count	313 Count	43 Count
1772548793	117 Count	308 Count	42 Count
1772547890	116 Count	304 Count	42 Count
1772546987	115 Count	302 Count	42 Count
1772546084	114 Count	301 Count	42 Count
1772545254	113 Count	301 Count	42 Count
1772544351	112 Count	300 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)