LU2EQD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LU2EQD-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1773184309	124 Count	730 Count
1773182509	123 Count	721 Count
1773180708	122 Count	710 Count
1773178907	121 Count	696 Count
1773177106	120 Count	677 Count
1773175318	119 Count	661 Count
1773173516	118 Count	651 Count
1773171716	117 Count	633 Count
1773169914	116 Count	633 Count
1773168114	115 Count	633 Count
1773166318	114 Count	628 Count
1773164511	113 Count	628 Count
1773162710	112 Count	626 Count
1773160910	111 Count	603 Count
1773159109	110 Count	583 Count
1773157308	109 Count	568 Count
1773155507	108 Count	555 Count
1773153713	107 Count	541 Count
1773151912	106 Count	519 Count
1773150111	105 Count	505 Count
1773148310	104 Count	494 Count
1773146510	103 Count	476 Count
1773144709	102 Count	455 Count
1773142908	101 Count	444 Count
1773141107	100 Count	435 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)