DK8VW-22 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DK8VW-22. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1788602925	0 C deg	18.8 C deg
1788601094	0 C deg	18.8 C deg
1788599280	0 C deg	18.7 C deg
1788599264	0 C deg	18.7 C deg
1788597449	0 C deg	18.7 C deg
1788597434	0 C deg	18.7 C deg
1788595604	0 C deg	18.6 C deg
1788593774	0 C deg	18.6 C deg
1788591956	0 C deg	18.6 C deg
1788591944	0 C deg	18.6 C deg
1788590126	0 C deg	18.6 C deg
1788590114	0 C deg	18.6 C deg
1788588298	0 C deg	18.6 C deg
1788588284	0 C deg	18.6 C deg
1788586464	0 C deg	18.6 C deg
1788586454	0 C deg	18.6 C deg
1788584624	0 C deg	18.7 C deg
1788582830	0 C deg	18.8 C deg
1788582794	0 C deg	18.8 C deg
1788581104	0 C deg	18.8 C deg
1788580964	0 C deg	18.8 C deg
1788579134	0 C deg	18.9 C deg
1788577304	0 C deg	18.9 C deg
1788575473	0 C deg	19.1 C deg
1788573643	0 C deg	19.1 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)