SP3NGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3NGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1776673748	259 Count	225 Count	10 Count
1776671947	255 Count	225 Count	10 Count
1776670146	251 Count	225 Count	10 Count
1776668345	247 Count	225 Count	10 Count
1776666543	243 Count	225 Count	10 Count
1776664741	239 Count	225 Count	10 Count
1776662940	235 Count	225 Count	10 Count
1776661139	231 Count	225 Count	10 Count
1776659338	227 Count	225 Count	10 Count
1776657537	223 Count	225 Count	10 Count
1776655736	219 Count	225 Count	10 Count
1776653935	215 Count	225 Count	10 Count
1776652134	211 Count	225 Count	10 Count
1776650333	207 Count	225 Count	10 Count
1776648532	203 Count	225 Count	10 Count
1776646731	199 Count	225 Count	10 Count
1776644930	195 Count	225 Count	10 Count
1776643129	191 Count	225 Count	10 Count
1776641328	187 Count	225 Count	10 Count
1776639526	183 Count	225 Count	10 Count
1776637725	179 Count	225 Count	10 Count
1776635924	175 Count	225 Count	10 Count
1776634123	171 Count	225 Count	10 Count
1776632349	167 Count	225 Count	10 Count
1776630548	163 Count	225 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)