SP6PTT Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PTT. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784678823	143 Count	906 Count	138 Count
1784677022	110 Count	738 Count	106 Count
1784675222	82 Count	559 Count	79 Count
1784673421	48 Count	380 Count	46 Count
1784671620	26 Count	194 Count	25 Count
1784669819	0 Count	0 Count	0 Count
1784668031	116 Count	962 Count	111 Count
1784666230	91 Count	735 Count	87 Count
1784664429	74 Count	577 Count	71 Count
1784662627	48 Count	350 Count	46 Count
1784660826	26 Count	185 Count	25 Count
1784659025	16 Count	105 Count	16 Count
1784657225	151 Count	1002 Count	138 Count
1784655424	145 Count	949 Count	133 Count
1784653623	137 Count	903 Count	127 Count
1784651822	110 Count	779 Count	106 Count
1784650022	93 Count	655 Count	90 Count
1784648221	65 Count	495 Count	63 Count
1784646435	40 Count	332 Count	39 Count
1784644634	13 Count	153 Count	13 Count
1784642833	126 Count	1110 Count	119 Count
1784641033	88 Count	805 Count	82 Count
1784639232	57 Count	565 Count	52 Count
1784637431	43 Count	433 Count	39 Count
1784635630	33 Count	370 Count	30 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)