SR8NDR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8NDR-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1772554765	131 Count	281 Count	129 Count
1772553564	86 Count	183 Count	85 Count
1772552364	27 Count	58 Count	27 Count
1772551163	500 Count	1086 Count	476 Count
1772548761	442 Count	921 Count	420 Count
1772547560	412 Count	855 Count	391 Count
1772546361	380 Count	795 Count	360 Count
1772391374	353 Count	770 Count	339 Count
1772388972	306 Count	652 Count	294 Count
1772387772	262 Count	554 Count	251 Count
1772386571	222 Count	465 Count	212 Count
1772385370	187 Count	385 Count	178 Count
1772377035	141 Count	290 Count	138 Count
1772375834	107 Count	219 Count	105 Count
1772374633	57 Count	121 Count	56 Count
1772372232	452 Count	1015 Count	434 Count
1772371031	396 Count	896 Count	379 Count
1772369830	346 Count	787 Count	330 Count
1772367429	295 Count	663 Count	281 Count
1772366227	250 Count	560 Count	237 Count
1772364396	216 Count	476 Count	209 Count
1772309749	215 Count	476 Count	209 Count
1772308548	186 Count	407 Count	181 Count
1772187720	185 Count	407 Count	181 Count
1772186519	161 Count	350 Count	158 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)