SP9LJE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765577793	337 Count	555 Count	300 Count
1765575993	327 Count	528 Count	291 Count
1765574192	315 Count	499 Count	280 Count
1765572391	289 Count	460 Count	255 Count
1765570591	269 Count	432 Count	236 Count
1765568790	244 Count	408 Count	212 Count
1765566989	234 Count	399 Count	203 Count
1765565197	221 Count	382 Count	191 Count
1765563397	182 Count	324 Count	153 Count
1765561596	165 Count	301 Count	137 Count
1765559795	155 Count	283 Count	128 Count
1765557995	143 Count	262 Count	117 Count
1765556194	123 Count	225 Count	98 Count
1765554394	113 Count	207 Count	89 Count
1765552593	103 Count	189 Count	80 Count
1765550792	90 Count	170 Count	68 Count
1765548991	68 Count	142 Count	47 Count
1765547190	57 Count	132 Count	37 Count
1765545390	32 Count	108 Count	13 Count
1765543599	30 Count	107 Count	12 Count
1765541797	29 Count	107 Count	12 Count
1765540003	28 Count	107 Count	12 Count
1765538195	27 Count	107 Count	12 Count
1765536395	26 Count	106 Count	12 Count
1765534594	25 Count	106 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)