F1MCO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F1MCO-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1776677400	57 Count	715 Count
1776675596	56 Count	711 Count
1776673792	55 Count	706 Count
1776671988	54 Count	702 Count
1776670184	53 Count	694 Count
1776668380	52 Count	690 Count
1776663012	45 Count	630 Count
1776659404	43 Count	618 Count
1776655797	41 Count	586 Count
1776653993	40 Count	577 Count
1776652189	39 Count	561 Count
1776650385	38 Count	543 Count
1776648581	37 Count	519 Count
1776646779	36 Count	498 Count
1776645017	31 Count	477 Count
1776643213	30 Count	455 Count
1776641409	29 Count	433 Count
1776637801	27 Count	401 Count
1776635998	26 Count	381 Count
1776634193	25 Count	361 Count
1776632390	24 Count	340 Count
1776630586	23 Count	315 Count
1776628782	22 Count	287 Count
1776625174	20 Count	250 Count
1776623415	15 Count	231 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)