WB6ETY-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB6ETY-4. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1776903510	1372	774	386	770	36
1776903190	1372	773	381	766	44
1776902789	1372	771	381	770	38
1776902070	1372	771	381	766	39
1776901390	1372	770	376	766	40
1776901350	1372	770	376	766	38
1776900631	1374	770	376	766	40
1776899910	1372	769	376	766	40
1776899589	1372	769	381	766	35
1776899190	1372	768	386	766	36
1776898470	1372	768	376	761	37
1776897790	1372	767	381	761	36
1776897753	1372	767	376	761	37
1776896311	1372	764	376	761	36
1776895990	1375	763	376	756	36
1776895591	1372	762	370	756	35
1776894870	1372	760	376	756	36
1776894190	1378	760	376	756	35
1776894150	1372	760	376	756	35
1776893430	1372	759	376	756	36
1776892710	1372	756	370	752	36
1776892390	1372	756	376	752	35
1776891990	1372	755	376	752	42
1776891271	1372	753	370	748	37
1776890590	1372	751	370	743	39

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)