DD7MH-55 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DD7MH-55. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1780605828	0 C deg	21 C deg
1780604010	0 C deg	21.2 C deg
1780602271	0 C deg	21.3 C deg
1780602215	0 C deg	21.3 C deg
1780600380	0 C deg	21.4 C deg
1780598607	0 C deg	21.2 C deg
1780596830	0 C deg	21.1 C deg
1780596754	0 C deg	21.1 C deg
1780595081	0 C deg	20.9 C deg
1780593140	0 C deg	20.9 C deg
1780591316	0 C deg	20.9 C deg
1780589501	0 C deg	20.8 C deg
1780587698	0 C deg	20.6 C deg
1780585880	0 C deg	20.6 C deg
1780585864	0 C deg	20.6 C deg
1780584048	0 C deg	20.5 C deg
1780582232	0 C deg	20.5 C deg
1780580415	0 C deg	20.4 C deg
1780578635	0 C deg	20.3 C deg
1780578600	0 C deg	20.3 C deg
1780576806	0 C deg	20.2 C deg
1780575026	0 C deg	20 C deg
1780573160	0 C deg	19.9 C deg
1780571352	0 C deg	19.8 C deg
1780569524	0 C deg	19.8 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)