F5ZZW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZZW-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789971269	312 Count	336 Count	167 Count
1789970663	311 Count	336 Count	167 Count
1789970057	308 Count	333 Count	165 Count
1789969450	305 Count	330 Count	163 Count
1789968844	304 Count	329 Count	163 Count
1789968238	302 Count	327 Count	162 Count
1789967632	299 Count	325 Count	160 Count
1789967026	298 Count	325 Count	160 Count
1789966419	296 Count	322 Count	159 Count
1789965813	294 Count	319 Count	158 Count
1789965207	293 Count	319 Count	158 Count
1789964601	290 Count	317 Count	156 Count
1789963995	287 Count	313 Count	154 Count
1789963389	285 Count	311 Count	153 Count
1789962782	283 Count	310 Count	152 Count
1789962176	281 Count	308 Count	151 Count
1789961570	279 Count	307 Count	150 Count
1789960963	278 Count	306 Count	150 Count
1789960357	275 Count	303 Count	148 Count
1789959751	272 Count	301 Count	146 Count
1789959369	271 Count	300 Count	146 Count
1789958762	268 Count	297 Count	144 Count
1789958156	266 Count	294 Count	144 Count
1789957550	263 Count	290 Count	142 Count
1789956943	260 Count	288 Count	140 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)