SP6TPX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TPX-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1781366218	47 Count	974 Count	12 Count
1781364417	46 Count	951 Count	12 Count
1781362616	45 Count	928 Count	12 Count
1781360815	44 Count	910 Count	12 Count
1781359014	43 Count	887 Count	12 Count
1781357213	42 Count	857 Count	12 Count
1781355412	41 Count	814 Count	12 Count
1781353611	40 Count	765 Count	12 Count
1781351810	39 Count	731 Count	12 Count
1781350009	37 Count	672 Count	11 Count
1781348219	25 Count	621 Count	0 Count
1781346418	24 Count	582 Count	0 Count
1781344617	23 Count	568 Count	0 Count
1781342816	22 Count	542 Count	0 Count
1781341015	21 Count	506 Count	0 Count
1781339214	20 Count	479 Count	0 Count
1781337413	19 Count	454 Count	0 Count
1781335612	18 Count	438 Count	0 Count
1781333811	17 Count	417 Count	0 Count
1781332010	16 Count	391 Count	0 Count
1781330209	15 Count	366 Count	0 Count
1781328408	14 Count	343 Count	0 Count
1781326618	13 Count	301 Count	0 Count
1781324817	12 Count	266 Count	0 Count
1781323016	11 Count	244 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)