DL1MPL-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL1MPL-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1773211266	0 C deg	7.8 C deg
1773209454	0 C deg	7.4 C deg
1773205820	0 C deg	7.7 C deg
1773205820	0 C deg	7.7 C deg
1773204011	0 C deg	7.7 C deg
1773200382	0 C deg	7.9 C deg
1773198571	0 C deg	8.2 C deg
1773196747	0 C deg	8.5 C deg
1773194950	0 C deg	8.9 C deg
1773194931	0 C deg	8.9 C deg
1773193115	0 C deg	9.4 C deg
1773191300	0 C deg	9.8 C deg
1773184041	0 C deg	11.8 C deg
1773180419	0 C deg	12.7 C deg
1773176780	0 C deg	13.6 C deg
1773176780	0 C deg	13.6 C deg
1773173150	0 C deg	14.9 C deg
1773173150	0 C deg	14.9 C deg
1773171336	0 C deg	15.6 C deg
1773171335	0 C deg	15.6 C deg
1773169521	0 C deg	16.2 C deg
1773167707	0 C deg	17 C deg
1773167707	0 C deg	17 C deg
1773164077	0 C deg	18.6 C deg
1773162262	0 C deg	19.4 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)