LU6MHO-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LU6MHO-8. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1773264993	18 Count	16 Count
1773264294	18 Count	16 Count
1773263094	18 Count	16 Count
1773261891	18 Count	16 Count
1773260691	18 Count	16 Count
1773259491	18 Count	16 Count
1773258291	18 Count	16 Count
1773257091	18 Count	16 Count
1773255891	18 Count	16 Count
1773254691	18 Count	16 Count
1773253491	18 Count	16 Count
1773252291	18 Count	16 Count
1773251091	17 Count	15 Count
1773249891	17 Count	15 Count
1773248692	17 Count	15 Count
1773247491	16 Count	14 Count
1773246297	16 Count	14 Count
1773245090	16 Count	14 Count
1773243890	16 Count	14 Count
1773242690	16 Count	14 Count
1773241490	13 Count	11 Count
1773241190	12 Count	10 Count
1773239988	12 Count	10 Count
1773238788	12 Count	10 Count
1773237588	12 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)