SQ9IKM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IKM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787560900	51 Count	169 Count	38 Count
1787560000	47 Count	163 Count	35 Count
1787559114	44 Count	157 Count	33 Count
1787558214	40 Count	149 Count	30 Count
1787557313	36 Count	138 Count	27 Count
1787556413	33 Count	124 Count	25 Count
1787555512	29 Count	112 Count	22 Count
1787554611	25 Count	97 Count	19 Count
1787553711	21 Count	85 Count	16 Count
1787552810	16 Count	74 Count	12 Count
1787551909	12 Count	53 Count	9 Count
1787551009	9 Count	36 Count	7 Count
1787550108	5 Count	20 Count	4 Count
1787549207	3 Count	12 Count	3 Count
1787548307	304 Count	1039 Count	245 Count
1787547406	300 Count	1000 Count	242 Count
1787546505	294 Count	972 Count	237 Count
1787545605	285 Count	951 Count	229 Count
1787544704	277 Count	916 Count	222 Count
1787543803	273 Count	886 Count	219 Count
1787542903	269 Count	862 Count	216 Count
1787542002	263 Count	833 Count	211 Count
1787541102	257 Count	807 Count	206 Count
1787540201	252 Count	781 Count	202 Count
1787539300	245 Count	751 Count	196 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)