SP8SOB-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SOB-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784698993	44 Count	53 Count	24 Count
1784698092	42 Count	52 Count	23 Count
1784697191	40 Count	50 Count	22 Count
1784695390	32 Count	41 Count	16 Count
1784693589	28 Count	37 Count	14 Count
1784692688	25 Count	33 Count	12 Count
1784691788	23 Count	30 Count	11 Count
1784690887	21 Count	27 Count	10 Count
1784689986	19 Count	24 Count	9 Count
1784689086	18 Count	24 Count	9 Count
1784688185	16 Count	21 Count	8 Count
1784687285	15 Count	19 Count	8 Count
1784686384	13 Count	17 Count	7 Count
1784685484	11 Count	15 Count	6 Count
1784684583	9 Count	12 Count	5 Count
1784683682	7 Count	10 Count	4 Count
1784682782	5 Count	8 Count	3 Count
1784681881	3 Count	6 Count	2 Count
1784680981	1 Count	3 Count	1 Count
1784678279	997 Count	963 Count	384 Count
1784677378	995 Count	960 Count	383 Count
1784676478	993 Count	957 Count	382 Count
1784675577	991 Count	955 Count	381 Count
1784674676	985 Count	948 Count	376 Count
1784673776	983 Count	947 Count	375 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)