YB1LZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YB1LZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Temp.*	Humidity*	Pressure*
1773822099	143	44	933
1773821944	142	44	933
1773821659	142	43	933
1773821055	143	40	933
1773820929	143	40	933
1773820804	143	40	933
1773820510	143	39	933
1773820144	143	40	933
1773819733	143	39	933
1773819629	142	40	933
1773819335	143	38	933
1773819239	143	38	933
1773819138	143	37	933
1773819007	144	32	933
1773818714	143	37	933
1773818590	143	38	933
1773818356	143	37	933
1773818162	143	38	933
1773818073	142	39	933
1773817624	142	39	933
1773817457	143	39	933
1773816614	143	39	933
1773815839	143	38	933
1773815806	143	39	933
1773815726	143	39	933

*Used Equation Coefficients:

Temp.: 0, 1, 110

Humidity: 0, 1, 0

Pressure: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)