F5ZMX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZMX-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1788568133	128 Count	279 Count	107 Count
1788567262	121 Count	248 Count	101 Count
1788566326	114 Count	222 Count	95 Count
1788565423	109 Count	207 Count	91 Count
1788564519	104 Count	185 Count	87 Count
1788563616	98 Count	169 Count	82 Count
1788562712	91 Count	156 Count	76 Count
1788561809	85 Count	144 Count	71 Count
1788560906	80 Count	131 Count	67 Count
1788560002	75 Count	121 Count	63 Count
1788559099	71 Count	109 Count	60 Count
1788558280	68 Count	103 Count	58 Count
1788557377	64 Count	93 Count	55 Count
1788556473	60 Count	86 Count	52 Count
1788555570	56 Count	80 Count	49 Count
1788554667	52 Count	74 Count	46 Count
1788553763	48 Count	66 Count	43 Count
1788552860	43 Count	58 Count	39 Count
1788551956	38 Count	49 Count	35 Count
1788551053	33 Count	42 Count	31 Count
1788550150	17 Count	20 Count	16 Count
1788549246	13 Count	15 Count	13 Count
1788548343	384 Count	1013 Count	336 Count
1788547440	365 Count	972 Count	318 Count
1788546536	360 Count	933 Count	314 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)